It is easy to gradually strip floor finish with Simix Multi-Surface Cleaner while also keeping floors clean and bright. We call this “Pre-Strip.”
​
Pre-stripping is easy. All you need to do is switch from your old liquid pH neutral cleaner to Simix Multi-Surface Cleaner. You will continue to clean as you always have with a mop and a bucket or an auto scrubber.
​
Materials needed:

• Mop and bucket or auto scrubber with red pads.
• Water
• Simix Multi-Surface Cleaner
• Pump-up sprayer

 

1. Mix ¼ oz (one small scoop) of Multi-Surface Cleaner per gallon of water in mop bucket or auto scrubber with red pads. Hot water works best.
2. Mop floors as you normally would or auto scrub floors as you normally would.
3. These methods will slowly remove floor finish while keeping the floors clean and bright.
   
4. Once there is no more gloss, you are ready for final strip.

If the edges have heavy buildup:

1. Mix 2 oz of Multi-Surface Cleaner per every gallon of water in a sprayer.
2. Spray areas of heavy build up and let the water/cleaner mixture dwell on those areas for at least 20 minutes.
3. Mop or autoscrub to pick up.

Next Step: Stripping

​The Simix Floor Program

Pre-stripping is part of the comprehensive Simix floor maintenance program that will save you time and money.

1. Pre-stripping
2. Stripping Boost
3. Coating
4. Cleaning
5. Recoating

This program requires just two products: Simix Multi-Surface Cleaner and Simix Multi-Surface Coating.

Learn more about the other steps in the program:

CLICK FOR STRIPPING BOOST

CLICK FOR COATING

CLICK FOR FLOOR CLEANING

CLICK FOR RECOATING